![]() ![]() If a direct communication attempt fails, the device will try to establish a routed communication, through other modules, which will be signalled by visual indicator pulsing yellow. Visual indicator pulsing green – the device attempts to establish a direct communication with the main controller. If roller blind does not stop after reaching bottom – decrease value of parameter 156,īack To Top Z-Wave network Adding the deviceĬommunication mode of the device may switch between direct and one using routing, especially if the device is on the limit of the direct range.If roller blind stops before reaching bottom – increase the value of parameter 156,.If roller blind does not stop after reaching top – decrease the value of parameter 155,.If roller blind stops before reaching top – increase the value of parameter 155,.Move roller blinds between extreme positions by clicking or switch:.By default, time of transition between extreme positions is set to 600 (6 seconds) in parameters 155 and 156.Roller blind with built-in driver positioning Correctly configured slats should not force the blinds to move up or down. Test whether the positioning works correctly. ![]() Repeat the previous step until satisfactory positioning is achieved.If after full cycle the slats do not reach end positions – increase the value of parameter 152,.If after full cycle a blind starts moving up or down – decrease the value of parameter 152,.Turn slats between extreme positions by holding or switch:.By default, time of transition between extreme positions is set to 150 (1.5 seconds) in parameter 152.The parameter 150 value will be set to 1 after calibration finishes.The device will perform the calibration process, completing full cycle – up, down and up again.Quickly release and click the B-button again.Press and hold the same switch again for at least 3 seconds.Press and hold or switch for at least 3 seconds.the device added to the Z-Wave network,.the momentary switch is connected to S1 and S2 terminals,.Make sure no part of the antenna sticks out of the wall switch box.Ĭalibration using connected momentary switch.Do not cut or shorten the antenna – its length is perfectly matched to the band in which the system operates.flush mounted metal boxes, metal door frames) may impair signal reception! Metal surfaces in the direct vicinity of the antenna (e.g. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |